RTI TheaterTouch T2 - How to Test Infrared Commands

Chapter 6 • IR Library Manager
77
HOW TO TEST INFRARED COMMANDS
After the TheaterTouch has learned a command, you can test it to make sure it behaves
properly.
1. Press the
SELECT
button while in the IR Capture Test Mode on frame 3 of
IR Capture page, this will test the last captured IR command.
The command will remain in memory (for testing) until it is overwritten
by the next captured command.
2. Make sure you point the TheaterTouch at the equipment to be controlled
when you press the
SELECT
button.
If the command does not work properly, it may need to be edited or re-
learned.
3. To close the IR Capture window on the remote press the
Main Menu
button.
SELECT
Button