Chapter 6 • IR Library Manager
75
HOW TO CAPTURE INFRARED COMMANDS
Once a donor remote control is properly aligned, the TheaterTouch is ready to start
capturing the IR commands and transferring them to the Infrared Library Manager
Software.
1. Make sure the TheaterTouch is in the IR CAPTURE
LEARN MODE
on
frame 2 of the IR
CAPTURE
page and says STATUS:
READY
.
The last frequency measured with the ALIGN function should be
displayed at the bottom of the screen. If it is not, you must go through the
Align Procedure again.
2. The communications cable should be connected to the TheaterTouch and
the PC. The TheaterTouch Designer software needs to be running with the
Infrared Library Manager
window open.
The dialog box should say
Edit View
on the title bar with the name of the
infrared library you are working in after it.
3. Click on the
Learn IR
command button and if you are still properly
aligned, you are ready to start capturing codes.
To Next Page
Loading...
