To Next Page

To Previous Page

Chapter 6 • IR Library Manager

Sustain -

Check this box to control whether or not the IR code should repeat if the

button is held down. Most infrared codes will transmit continuously as long as the

button is held down, but some infrared receivers may not work properly if the

command is repeated at all. If the Sustain button is checked, the code will be

transmitted for as long as the button is held down, or the

Minimum Repeat

times,

whichever is greater. If the Sustain button is not checked, the code will be

transmitted only the

Minimum Repeat

number of time regardless of how long the

button is held down.

Apply –

Use this to save any changes you have made.

Test –

Use this to test any changes you have made to a command. Make sure to have

the TheaterTouch hooked up to the computer with the serial cable and have the

remote in

Test IR

Mode on frame 3 of the

IR Capture

page in the Control Panel.

Questions and Answers:

Need help?

Do you have a question about the RTI TheaterTouch T2 and is the answer not in the manual?

RTI TheaterTouch T2 Specifications

General