CHAPTER 6
Pre-Walk-Thru Checklist
Following the instructions fully to this point you have
successfully completed the following checklist:
❐
Located the base station properly.
❐
Connected power to base station
❐
Connected the 1/2-wave antennas to the
base station. Checked frequency range of
the antennas with the frequency of the
base station by correctly matching color
codes.
❐
Connected 1/4-wave antenna to the
beltpack. Checked frequency range of
the antennas with the frequency of the
beltpack by correctly matching color
codes.
❐
Base station transmit power switches in
the correct positions.
❐
Transmit mode switch on beltpack set
correctly.
❐
Set wired intercom type correctly.
❐
Connected headsets to base stations (if
needed) and all beltpacks.
❐
Connected the base station to any
auxiliary audio, intercom, external P.A.
system, or relay contact detect circuit, if
needed.
❐
Installed batteries in the beltpack.
❐
If you massed any of the above
instructions, go back and complete that
instruction before going on.
To Next Page
Loading...
