62 System Operation BTR-800, TR-800, TR-825
Transmit Screen
The Transmit screen allows the user to set the beltpack transmit
frequency. Factory-defined groups will allow only a set number
of pre-defined frequencies to be selected. User-programmable
groups will allow the user to change the frequency in 25 kHz
steps.
• Press [MENU] once from the group/channel screen to
arrive at the transmit frequency screen.
• Press [SET] to edit the frequency. The number will start
flashing. Factory-defined groups will allow only a set
number of pre-defined frequencies to be selected. User-
programmable groups will allow the user to change the
frequency in 25 kHz steps.
• Use the [UP]/[DOWN] arrow buttons to change the
frequency.
• Press [SET] to place the beltpack on the frequency selected.
If [SET] is held down, during that time the group/channel is
displayed so the user is aware of what transmit channel the
unit has been placed. Once [SET] is released, the unit
returns to the transmit frequency screen with nothing
flashing.
• Pressing [SET] once more will start the editing sequence
over again. Pressing [MENU] during transmit frequency
edit will end editing and send the user back to the transmit
screen without any changes.
To Next Page
Loading...
