BTR-800, TR-800, TR-825 System Operation 63
Receive 1 Screen
The Receive 1 screen allows the user to set the beltpack receiver
1 frequency. This corresponds to the base station’s transmit 1
frequency. In factory-defined groups receiver 1 is not
changeable. User-programmable groups will allow the user to
change the frequency in 25 kHz steps.
• Press [MENU] twice from the group/channel screen to
arrive at the receive 1 frequency screen.
• (User-Programmable Groups Only) Press [SET] to edit the
frequency. The number will start flashing. Factory-defined
groups can’t be changed; so pressing set will do nothing at
this screen. User-programmed groups will start flashing and
allow the user to change the frequency in 25 kHz steps.
• (User-Programmable Groups Only) Use the [UP]/[DOWN]
arrow buttons to change the frequency.
• (User-Programmable Groups Only) Press [SET] to place
the beltpack on the frequency selected. If [SET] is held
down, during that time the group is displayed so the user is
aware of what group the unit has been placed. Once [SET]
is released, the unit returns to the receive 1 frequency screen
with nothing flashing.
• (User-Programmable Groups Only) Pressing [SET] once
more will start the editing sequence over again. Pressing
[MENU] during receive 1 frequency edit will end editing
and send the user back to the receive 1 screen without any
changes.
To Next Page
Loading...
