Ruida Technology RDC6332G - 8.3 Introduction to menus

RDC6332G Control System User Manual
33
/
47
© 2015 Ruida Technology. All Rights Reserved
User can press “Z+/-” Keys to move the cursor on the intent parameter, then “Numeral” to
modify the parameter if needed. “OK” to validate the change, and “Exit” to invalidate the change.
Please notice that “Z+/-” Keys are used to move the cursor but not to move Z axes when the
cursor is on the layer on the main interface, that’s to say, if user want to move the Z-axis, firstly
press the “CL” key to let the cursor disappear.
8.3 Introduction to menus
Press the “Menu” key when the screen is on the main interface, it will show as below:
Press “Y+/- “to select the intent entry, then press “Enter” Key to check the sub menu.
Figure: 8.2-7
Figure: 8.3-1