EasyManuals Logo

Ruida Technology RDC6332G User Manual

Ruida Technology RDC6332G
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
RDC6332G Control System User Manual
37
/
47
© 2015 Ruida Technology. All Rights Reserved
When the machine leave factory, to store all the debugged
manufacturer parameters and user parameters through “Set Para”, so
“Recover Para” can be used to recover all the parameters at any time.
8.3.4 User para
When the cursor is on “User para” entry, if “Enter” key is pushed, the screen will show as
below:
The default cursor is on “Read” button, push “Enter” key to read all the user parameters. If
some parameters are changed, then press “Write” button to save the new parameters. “Write”
button can be pressed only after “Read” button is pressed.
8.3.5 Machine para
When the cursor is on “Machine para” entry, press “Enter”, the screen will show as below:
Figure: 8.3-7
Figure: 8.3-8
Prompt

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ruida Technology RDC6332G and is the answer not in the manual?

Ruida Technology RDC6332G Specifications

General IconGeneral
BrandRuida Technology
ModelRDC6332G
CategoryController
LanguageEnglish

Related product manuals