RDC6332G Control System User Manual
38
/
47
© 2015 Ruida Technology. All Rights Reserved
The default cursor is on “Read” button, push “Enter” key to read all the machine parameters.
If some parameters are changed, then press “Write” button to save the new parameters. “Write”
button can be pressed only after “Read” button is pressed.
8.4 Introduction to file function
8.4.1 Memory file
On the main interface, press “File”, it will pop up dialog box as below:
When showing this menu, the system would read the memory file firstly, the file name and the
running times would be listed in the left area, and the selected file is previewed at the top right area.
“Y+/-“keys could be used to move the cursor on the file name list. When the cursor is on a target
file name, presses “Enter” key, the selected file will be previewed on the main interface.
Press “Home” when the cursor is on a selected file, the screen will show as below:
To Next Page
Loading...