EasyManuals Logo

Ruida Technology RDC6332G User Manual

Ruida Technology RDC6332G
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
RDC6332G Control System User Manual
34
/
47
© 2015 Ruida Technology. All Rights Reserved
8.3.1 System information
When the cursor is on “System info” entry, if “Enter” Key, the screen will show as below:
The default cursor is on “Read” button, push “Enter” key to read all the system info. and the
limit info.. “Z+/- keys could be used to move the cursor, and when the cursor is on “System info”
label, “Y+/-“ keys could be used to change the label between “System info” and “Limit info”
8.3.2 System config
When the cursor is on “Sys config” entry, if “Enter” Key is pushed, the screen will show as
below:
The default cursor is on “Read” button, push “Enter” key to read the config information.
“Z+/-“key could be used to move the cursor to select the intent label. If some value is changed,
move the cursor to “Write” button and push “Enter” key, then the changed value could be saved.
“Lcd type can’t be changed.
There are two options in “Com” label, “Ethernet” and “USB”. If users want to change this
Figure: 8.3-2
Figure: 8.3-3

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ruida Technology RDC6332G and is the answer not in the manual?

Ruida Technology RDC6332G Specifications

General IconGeneral
BrandRuida Technology
ModelRDC6332G
CategoryController
LanguageEnglish

Related product manuals