RDC6332G Control System User Manual
6
/
47
© 2015 Ruida Technology. All Rights Reserved
1.3 Comparison of Controller Performance
One-way 5V,
one-way 24V,
independent
Only one-way 24V (compatible
with 36V for power supply, but
not recommended)
Only
one-way
digital
control port
One-way digit
and one-way
analog
Two-way digits and two-way
analog port, settable
independently and non-interacted
Support USB
disks with small
capacity
Support all USB disks with
different capacities
Capable of checking defective
track and formatting and good in
fault tolerance
4 ways (two for general, two for
specialties)
1-way (low
current, so
additional drive
is needed)
4-ways (500mA high current for
each, OC output, two for general,
two for specialties)
Power-off
restart for
Engraving
YES (the work time accurate to
1ms)
Online Updata
Controller
Program
Online
Modification
Laser
Power/Speed
Offline
Modification
Layer
parameters
Online Updata
Startup
Display
File
dynamic/static
preview
Modification
Factory/User’s