Ruida Technology RDC6332G - 8.3.3 Function sub menu

RDC6332G Control System User Manual
35
/
47
© 2015 Ruida Technology. All Rights Reserved
value, a password would be needed, show as below:
8.3.3 Function sub menu
When the cursor is on “Func” entry, press “Enter”, the screen will show as below:
If the cursor is on “Origin X enable”, press “Enter” to enable or disable the selected origin, if
it’s enabled, the color frame would be red, otherwise it’s green.
 Multiple Origin Enable: “Yes” or “No” can be selected. If you select “No”, the system
will use the single-origin logic. You can press the “Origin” key and set the origin, and
only this origin can become valid. If you select “Yes”, the system will use the
Figure: 8.3-4
Figure: 8.3-5
Figure: 8.3-6