RDC6332G Control System User Manual
46
/
47
© 2015 Ruida Technology. All Rights Reserved
(4) Go Scale Parameters Setting
Go Scale Mode: “close laser go scale” means idling, for frame preview; “cutting frame open laser”
means that cut off the well-processed graphics manually; “4-corner Dotting” means to emit the
light at four corner points of the frame, laser one point and the other places turning off. The size
and position of this graphics can be checked intuitively through the four points. The speed is the
speed value set on the keyboard when the system is idle. For light output, its minimum/maximum
power is the corresponding value set on the keyboard when the system is idle (The laser power on
the 4-corner dotting means the setting maximum power).
Go Scale Blank Distance: It means whether to extend a certain length outside the actual frame of
the figure on the preview/cutting of frame.
If the frame crosses the border, the interface will prompt it. If the
Enter key is pressed at this time, the system will cut the border at the
maximum/minimum coordinates, and then framing operation. This
operation can be given up.
(5) Other User Parameters
Array Mode: Two-way array or one-way array can be selected, only be effective for virtual array.
Two-way array means cutting the array back and forth in sequence; one-way array means the
cutting the array always from one direction to another. When in one-way array, the action mode
and fluency of each array elements are completely the same, which takes a little more time than
two-way array. Two-way array is the default option.
Return Position: The locating point and the machine origin point can be selected. This parameter
decides the parking position of laser head after each processing.
Delay before Feeding: set the time: 0~300s. The lagged time can facilitate user’s feeding and
picking on the feeding device. The previous work is completed and delayed the value, the feeding
axis begins to move. During the period of delay, it is convenient to feeding and select material for
user.
Delay after Feeding: set the time: 0~9.9s. It is facilitated the feeding device delay debouncing
after moving to the correct position, and waiting for the 2
nd
work when the feeding axis stands still
completely.
Focus Depth Setting: it means the distance from the lens focal point of laser head to Z-axis
original point. If there is no automatic focusing function, this parameter is invalid.
Backlash X: The backlash of X-axis, set the value according to the actual machine, accurate to 1
um, if this value is not 0, the control system will make compensation for backlash.
To Next Page
Loading...