RDC6563F Standalone Fiber Cutting Control System User Manual V2.0 11
SHENZHEN RUIDA TECHNOLOGY CO., LTD
1.2 RDC6563F main technical parameters
1.2.1 RDC6563F main technical parameters
Supports up to 6 axes of high speed motion, and with a maximum pulse frequency of
500 KHz.
Each axis supports positive and negative limits, servo alarm input detection and
protection.
Linear/Arc/B-spline interpolation accuracy +/- 0.5 pulses.
Supports small circle speed limit, power following functions.
15 general-purpose opto-isolated inputs compatible with 5V/12V/24V logic voltage.
15 general-purpose opto-isolated OC gate output, maximum 300mA drive capability
(with freewheeling protection), it can directly drive 24V/5V DC relay.
S-type acceleration and deceleration control and adaptive speed look-ahead
processing ensure smooth running.
Lasers can support a variety of laser types such as fiber optics and glass tubes.
Support 5V, 24V PWM / L_ON laser control signal output.
Support 5V, 10V analog voltage laser power control output.
1.2.2 Z Axis following system technical parameters
The dynamic following accuracy is less than 0.1mm.
The detection accuracy is less than 0.01mm.
Capacitance detection range is 0 to 9.9mm.
-10V ~ +10V servo drive analog voltage control output.
The maximum speed can reach 800mm/s, and the maximum acceleration can reach
10000mm/s^2.
To Next Page
Loading...
