RDC6563F Standalone Fiber Cutting Control System User Manual V2.0 85
SHENZHEN RUIDA TECHNOLOGY CO., LTD
to unreasonable parameter setting.
3) Manually trigger the upper and lower limit bits, it will prompt [upper and lower limit
trigger], it means normal. If the limit polarity is wrong, please set the limit switch polarity
correctly in the vendor parameters.
4) Please connect the motor cable correctly according to the motor driver model and set
the driver parameters. For details, please refer to the driver's instructions.
5) After the parameters are set correctly, connect the motor, the system is powered on,
press the [Z+] [Z-] button to check the moving direction of the cutting head. If the
direction of movement is wrong, modify the [Polarity] parameter until the movement
normal. If the encoder polarity is wrong, modify the [Encoder Polarity] parameter until
the motion is normal.
6) When using in the first time, perform [Servo Calibration] with [Function] to eliminate the
influence of servo zero drift.
7) Perform [Capacitor Calibration] through [Function] to calibrate the sensor. If the
calibration curve is smooth and the calibration result is normal, you can click “enter” to
save the data.
8) On the panel, press the [Follow] button. At this time, the cutting head will drop to the
focus position (the height of the nozzle). Press it again and it will be lift up to the lift
height.
9) Perform [Auto Tuning] from [Function] to optimize the internal parameters automatically.
10) If the above procedure is normal, other tests can be performed.
1) According to the laser model, wire it correctly according to the wiring diagram.
2) Set the laser type to fiber laser in the vendor parameters and set other related
parameters correctly.
3) Press [Function] → [Additional Function] on the panel to correctly set the relevant
parameters of the pulse, and set the pulse power to about 20%.
4) Machine power on, wait about 1 minute, and then press the [Shutter] button on the
panel to open the shutter.
5) Press the [pulse] button on the panel to check if the laser. If the laser is off, check the
wiring or parameters.
6) If the above procedure is normal, other tests can be performed.
Before the cutting test, please ensure that the wiring is correct and the controller parameters
To Next Page
Loading...
