RDC6563F Standalone Fiber Cutting Control System User Manual V2.0 47
SHENZHEN RUIDA TECHNOLOGY CO., LTD
compensate for the backlash.
The height of the upper jump during the cutting process.
The height of the cutting head when the entire graphic
cutting.
It is the speed at which lifting during the cutting process.
It is the maximum speed following the cutting process
When the delay mode is used, the time the cutting head
rises is considered to have been in place if beyond this
time.
When the delay mode is used, the time the cutting head
descends is considered to have been in place beyond
this time.
When the delay mode is used, the lifting time of the
cutting head after processing is considered to be in place
after this time.
If the software limit is enabled, when the limit is triggered,
the limit protection will be generated; if the limit is
disabled, when the limit is triggered, no protection. When
the upward movement exceeds the origin coordinate
value (the origin coordinate is 0), the software limit is
triggered; when the downward motion exceeds the
maximum stroke, the soft limit is also triggered.
Increasing this parameter can increase the response
speed of the following, but it is easy to cause oscillation
during following.
During the cutting process, when the cutting head is
moving down, the delay time is started in advance.
Different gases are used for punching and cutting. When
the perforation is switched to the cutting, the time is
delayed, the gas in the trachea is drained, and the mixed
gas is prevented.
If the collision alarm is enabled, if the cutting head occurs
during the movement, the cutting head will automatically
be lifted to a safe height; if the collision alarm is
prohibited, the collision protection will be ignored.
This parameter should not be set too large. The
excessive alarm filter coefficient will make the cutting
head fail to lifting protection in time after the collision
To Next Page
Loading...
