RYTEC System 3 - Page 23

17
SYSTEM STARTUP—PARAMETERS
P. 2 31 ±60 increments Open limit adjustment.
(For minor adjustments to the open position of the door. This
adjustment resets to 0 if the limits are reset.)
0
P. 2 44 0 – 3 Partial position
0: parameter off
1: half-open position
2: two-thirds-open position
3: operator-established position
P. 9 20 Error history (last four errors saved)
View? – press enter key to view errors (use up or down key to
scroll through failures)
#Clear? – press enter key to clear saved setting
#Exit? – press enter key on keypad to exit parameter
P. 9 80 0 – 4 Operating mode
0. Standard door open and close
1. jog door close/standard open
2. jog door close/jog open
3. emergency jog close/jog open with all inputs (photo eyes,
encoder, reversing edge, etc.) ignored
4. test mode – door automatically cycles open and closed
(cycle time set with ACL1)
0
P. 9 99 Password (for accessing Service Levels 1 and 2)
Parameter Range Service Level 1 Parameters (Password = 5) Factory
Setting