Need help?Do you have a question about the Sagem SAGEM-LINK F and is the answer not in the manual?
General| Brand | Sagem |
|---|---|
| Model | SAGEM-LINK F |
| Category | Microphone system |
| Language | English |
Steps for powering up the SAGEM LINK F terminal after installation.
Procedure for aligning antennas using Receive Signal Level (RSL).
Details on connecting the IDU to external devices via front and rear panels.
Procedure to measure and record the receive spectrum around receive frequency.
Describes how to compare actual receive signal level with expected value.
Tests to be performed on all used 2 Mbit/s access using a BER analyzer.
Procedure for performing a Bit Error Rate (BER) test.
Covers operations to start and configure main parameters of Sagem Link F radios.
Essential parameters to configure before establishing the link.
Parameters to adjust after the link has been established.
Steps to diagnose problems: define symptom, isolate, and fix.
Description of LEDs on IDU front panel and cable interface module.
Information on link status and alarm data via Pilot software.
Steps to configure Ethernet settings via Pilot software.
Troubleshooting common Ethernet bridge and LAN configuration issues.
Technical specifications for the transmitter, including output power and steps.
Technical specifications for the receiver, including receive level and BER thresholds.
To Next Page