Sagem SAGEM-LINK F - Upgrading a 2 X2;4 X2 Mbit;S IDU

SAGEM-LINK F 288055571-04
Installation and Operation Manual
Page 139/142
Issue 04 : July 2005
Reproduction and communication prohibited without the written permission of Sagem Communication
Upgrading a 2x2/4x2 Mbit/s IDU
Some low cost SAGEM LINK F versions are working only at two data rates : 2x2/4x2 Mbit/s. In order to extend
the capacity to the full range 2x2/4x2/8x2/16x2 Mbit/s, it is necessary to enter a registration key.
Contact your Sagem representative to obtain this key.
To know what are the capacities supported by the equipment, connect the Pilot software to the IDU and go to
the menu Parameters / Read IDU Parameters / Local.
The following window appears :
Available
capacities
The available capacities are indicated on the top of the screen. In the above example, the IDU work only at
two data rates 2x2 and 4x2 Mbit/s.
In order to extend the capacity to the full range, a registration code is required. This registration code depends
on the "IDU serial Number" and "IDU Card Serial Number".
Contact your Sagem representative to obtain this registration code.
To enter the registration code, go to the menu : Tools/ QPSK/Full Mode Registration.
The following screen appears :