SAGEM-LINK F 288055571-04
Installation and Operation Manual
Page 77/142
Issue 04 : July 2005
Reproduction and communication prohibited without the written permission of Sagem Communication
Note : There is no internal clock in Sagem-Link F equipment. The absolute time is given by the PC
which is connected.
3.3.3.4 - Clear Equipment Event Log
To begin a new measurement on local or remote equipment click on the menu Clear Eqp Events Log /
Local or Remote :
3.3.4 - Parameters Menu
When clicking on the Parameters menu, this screen appears :
The parameters section gives an information on the hardware and software versions of the equipment,
and on the current parameters.
These informations are available for the local and the remote equipment.
3.3.4.1 - Read IDU Parameters
When clicking on this menu, the following screen appears :
To Next Page
Loading...