SAGEM-LINK F 288055571-04
Installation and Operation Manual
Page 54/142
Issue 04 : July 2005
Reproduction and communication prohibited without the written permission of Sagem Communication
• Link ID Code : this code is used to identify the link and to avoid data recovery from an other
link at the same frequency. Link ID Code of the local and remote terminals must be the same.
Once these settings are completed, remove the mute by clicking on the transmit power slide, and
select the wanted transmit power. Verify that ATPC is still in "OFF" position.
The terminal is now ready for transmission, it is necessary to repeat the same operations with the
remote terminal to establish the link.
Normally, if main parameters are compatible and if there is enough receive level, the link should be
established, and the main Pilot screen of the local terminal should look like that :
Main Pilot Screen for a 1+0 Configuration
To Next Page
Loading...