32 • X/Z Mode Reporting ER-180 Electronic Cash Register AU
Cash In Drawer Declaration
In the System Option #1 Programming, cash-in-drawer declaration can be programmed
compulsory. Cash-in-drawer declaration is performed by adding the total of each type of media in the
drawer, and pressing the SUBTOTAL key. Depression of the SUBTOTAL key with numeric will
enter the information that the cash-in-drawer declaration performed, and reports in X position and Z
position will be allowed. In this case, the difference of input amount and cash in drawer is displayed.
After this declaration, you can not take any registering operation, if not reporting in X mode or Z
mode.
TOTAL ENTERED BY KEY-INPUT ->
TOTAL IN CASH DRAWER ->
DIFFERENCE ->
SAMPLE RECEIPT
02-01-10___14-30
180•00
184•26
-4•26
029-00
CA
_
AT
1
To Next Page
Loading...
