SAM4s ER-180T Operator's & Programming Manual v1.4 Getting Started 15
Ram Clearing
All Memory Clear
RAM clearing the cash register erases all programming and totals. Use this program the first
time the cash register is programmed.
WARNING: This is a one time procedure. Do not repeat this procedure after the cash
register is programmed; it causes all programs and totals to be erased.
Follow this procedure to clear totals from memory:
1. Unplug the ECR.
2. Turn the control lock to the S position. (The S position is a hidden position one
position clockwise from the PRG position.)
3. Press and hold the CHARGE key on key board and plug the ECR into a power
source.
4. When the buzzer beeps release the CHARGE key. Press the upper left key of the
keyboard, then the lower left key, then the upper right key, and finally press the lower
right key.
1
3
2
4
5. When memory is cleared, the register prints a message “RAM ALL CLEAR OK!”
Memory is cleared and the default program is installed.
CHARG
To Next Page
Loading...
