SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming 53
Text Entry Descriptor Program Method
1. Turn the key lock to the P position.
2. Refer to the chart on the next page. Enter the address “Y” to determine the type of
descriptor you are programming (i.e. Department, PLU, Function, etc.) For example
press “1” to program a department.
3. Again referring to the chart, enter the number “XXXX” that determines the specific
department, PLU, function, etc. that you wish to program. For example, press “0012” to
program department #12.
4. Enter the text by pressing a text key one or more times to select the desired character or
symbol. Wait 2-seconds before entering the next character. The display will count the
number of characters you have entered. Always wait until you see the display counter
increment before entering the next character. For example:
a. Press
5
BC
3-times for “C”. Wait 2-seconds.
b. Press
5
BC
1-time for “A”. Wait 2-seconds.
c. Press
7
TUV
1-time for “T”. Your descriptor will read “CAT”
To enter numerals as text, press the appropriate numeral key on the 10-keypad.
RETURN
DOUBLE
To enter double-size characters, press the RETURN/DOUBLE key before each
character. Note that each double-size character uses 2-character positions.
VOID
CAPS
All characters are capitalized by default. To enter lower-case descriptors, press
VOID/CAPS before entering characters. All characters for this descriptor will be
lower-case until you press the VOID/CAPS key again.
CANCEL
BACK
To back up a character, press CANCEL/BACK.
TAX
SPACE
To insert a space, press TAX/SPACE.
Note that preamble/postamble characters will always be centered.
5. After you have completed your descriptor entry, press the SUBTOTAL key.
6. If you wish to enter additional descriptors, continue from step 2 above. When you are
completed, press the CASH/TEND key to end the program.
Use the flowchart below as a program guide.
SUBTOTAL CHARACTE RS
CASH/TEND
=
Repeat for each
Descriptor
SUBTOTAL
X X
X X Y
To Next Page
Loading...
