Sam4s ER-180T Series - Currency Conversion Rate - Program 90

SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming  71
Currency Conversion
Note: The currency conversion function is located on the same key as the receipt on/off
function. Inside of a sale, the function operates as currency conversion; outside of a sale
the key operates as the receipt on/off function.
Currency Conversion Rate - Program 90
1. Turn the control lock to the P position.
2. To begin the program, enter 9 0, press the SBTL key.
0 SUBTOTAL9
3. Enter the exchange rate of up to 7 digits (do not enter the decimal point), and
then enter a number from 0 to 7 to indicate the decimal position. See "Currency
Exchange Rate Programming Examples" below.
Exchange Rate
Decimal
Position
4. Press the RECEIPT ON/OFF C/CONV keky on the keyboard.
RCPT ON/OFF
C/CON
V
5. Press the CASH/TEND key to finalize the program.
CASH/TEND
(
=
)
Currency Exchange Rate Programming Examples
Note: Foreign currency exchange rates may be stated as “foreign currency in dollars”, or
“dollars in foreign currency”. Use the rate stated in “dollars in foreign currency” when you
are programming this section.
The US dollar (home currency) is worth 1.3720 Canadian dollars (foreign currency).
CASH/TEND
(
=
)
RCPT ON/OFF
C/CONV
4 1 3 7 2 0
Exchange Rate
Decimal
Position
The US dollar (home currency) is worth 110.24 Japanese Yen (foreign currency).
2 1 1 0 2 4
Exchange Rate
Decimal
Position
CASH/TEND
(
=
)
RCPT ON/OFF
C/CONV