Sam4s ER-180T Series - Management Reports; X & Z Reports; Running a Report - General Instructions; Report Table

SAM4s ER-180T Operator's & Programming Manual v1.4 Management Reports  43
Management Reports
X & Z Reports
System reports are divided into two basic categories:
 X reports, which read totals without resetting
 Z reports, which read totals and reset them to zero
Running a Report - General Instructions
1. Refer to the “Report Table“.
2. Select a report type and the report mode.
3. Turn the control lock to the position indicated.
4. Enter the key sequence for the report you have selected.
Report Table
Report Type
Report
Number
Report
Mode
Control Lock
Position
Key Sequence
1 X X 1 – SBTL
Z Z 1 – SBTL
X2 X 201 – SBTL
Financial/Dept
Z2 Z 201 – SBTL
2 X X 2 – SBTL
All PLU
Z Z 2 – SBTL
3 X X 3 – SBTL
All Clerk
Z Z 3 – SBTL
Print Electronic
Journal
300
X X 300 - SBTL
Reset Electronic
Journal
399 Z Z 399- SBTL