SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming 49
Program Mode Programming
Default Programming
All departments are nontaxable and open, without entry limits by default status programming
of "00000000".
All system options are set to 0 in default programming, unless otherwise noted. Change only
the options that will deviate from default programming. There is no need to re-enter an option
status of 0, since 0 is its original setting.
All programming (unless otherwise noted) is done with the control lock in the P position.
Each section details a specific area of register programming.
To Next Page
Loading...
