Sam4s ER-180T Series - Date and Time Programming

18  Quick Program Guide SAM4s ER-180T Operator's & Programming Manual v1.4
Date and Time Programming
Use this program to set the clock and calendar on your ER-180T Series. The date changes
automatically. After initial setting, time changing will probably be required only for
beginning and ending daylight savings time.
1. Turn the control lock to the P position.
2. To begin the program, enter 1 3 0 0, press the SBTL key.
0 SUBTOTAL 0 3 1
3. Enter time in military standard time (based on 24 hours), must be four digits
(i.e. 1300 hours = 1:00 PM); press the X/TIME key.
H H
X/TIME
(
X
)
M M
4. Enter the date in MM (month) DD (day) and YY (year) format. Press the
X/TIME key:
M M D D Y Y
X/TIME
(
X
)
5. Press the CASH/TEND key to finalize the program.
CASH/TEND
(
=
)