Sam4s ER-180T Series - Programming the Postamble Logo Message

SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming  77
Programming the Postamble Logo Message
A preamble message of up to six lines can be printed at the top of each receipt.
Each line can consist of up to 24 characters.
1. Turn the key lock to the P position.
2. To begin the program, enter 7 5 0, press the SUBTOTAL key.
0 SUBTOTAL 5 7
3. Refer to the chart below and enter the number that represents the line you wish
to program; press the X/TIME key.
X
X/TIME
(
X
)
X Message Line
1
1
st
line of Postamble
2
2
nd
line of Postamble
3
3
rd
line of Postamble
4
4
th
line of Postamble
5
5
th
line of Postamble
6
6
th
line of Postamble
4.
SUBTOTAL
Enter up to 24
three-character
codes
5. Press the CASH/TEND key to finalize the program.
CASH/TEND
(
=
)