Sam4s ER-5100 - Default Level Programming; Clerk Secret Code & Drawer Assignment Programming

21
2.5 DEFAULT LEVEL PROGRAMMING
The default level programming is the “top” or “surface” level returned to after each department when
options are set for pop-up levels. ( Refer to SYSTEM OPTION ADDRESS 57, Page 42 )
EX )
2.6 CLERK SECRET CODE & DRAWER ASSIGNMENT PROGRAMMING
NOTE : If you want to use 15 clerks system, you should set the SYSTEM OPTION ADDRESS 28 to 4
( Page 40 ).
When you want to use the CLERK CODE SYSTEM, you should set the SYSTEM OPTION ADDRESS 28.
This programming assigns a clerk code number to each clerk. The code number is used by the clerk to log
on for operations.
( 1 ) Press the one of “CLERK ( 1, 2, 3 or 4 )” keys. Any clerk key makes no difference.
( 2 ) Press the clerk number ( 1 ~ 15 ) and press the “DECIMAL POINT ( . )” key.
( 3 ) Enter the clerk secret code up to 6 digits, and then press the “#/NS” key.
( 4 ) Press the drawer number ‘1’ or ‘2’ and then press the “CASH/TEND” key to finalize the clerk
programming.
( X ) ( 6 Digits Code ) ( X )
( 1, 2, 3 or 4 ) CLERK NO. ( 1 ~ 15 ) DRAWER NO.
( 1 or 2 )
NOTE : Default drawer assignment for all clerks is drawer 1.
#/NSCLERK DECIMAL ( . )
LEVEL 2 LEVEL 2
CASH/TEND