Sam4s ER-5100 - Plu Link Programming; Removing or Deleting a Plu

34
2.9.4 PLU LINK PROGRAMMING
This programming is used to link two or more PLUs.
The second PLU ( B ) will be automatically registered when the first PLU ( A ) is registered.
PLU NO. ( A ) PLU NO. ( B )
2.9.5 REMOVING OR DELETING A PLU
In order to “de-activate” a PLU, or “remove” its status and linked department.
Deleted or inactivated PLUs will not be allowed to register.
( 1 ) Enter the PLU number ( 1 ~ 1000 ), and press the “PLU” key.
( 2 ) Press the “VOID” key.
NOTE : PLUs with a total may not be removed ( or deleted ).
Issue the PLU report in “Z” mode before removing any PLU with a total.
#/NS CASH/TEND
PLU
VOID PLU
X X X XX X X X
X X X X