75
1 REPORT MODES
REPORT TYPE TOTALS Z Counter REMARKS
X Not reset Not advance
Z Reset to ‘0’ Advance
X2 Not reset Not advance Period-to-date report
Z2 Reset to ‘0’ Advance Period-to-date report
NOTE : If you don’t want to open the drawer when the reports are run,
set SYSTEM OPTION ADDRESS 5 to value ‘b’. ( Page 38 )
2 CASH DECLARATION
If the compulsory cash declaration is programmed ( SYSTEM OPTION ADDRESS 5 ),
the cash declaration must be performed in “X / Z” mode prior to taking X / Z reports.
START AMOUNT OR EXIT
NOTE : After doing cash declaration in the ‘X / Z’ mode, if you turn the control key to any other
position except the ‘X / Z’, the cash declaration function will be lost.
So if you want to print the reports, you should perform the cash declaration again.
CASH/TENDCASH/TEND
CASH/TEND
CHECK
To Next Page
Loading...
