62
16.6 TENDERING WITH CURRENCY CONVERSION
You must program the “CONV” key.
If you don’t program this key, an error will occur when you enter the “CONV” key.
AMOUNT ( Foreign Currency )
16.7 POST TENDERING
NOTE : If you want to use post tendering function, you must set SYSTEM OPTION ADDRESS 13
to 1 ( Page 39 ).
Post tendering function is only allowed on cash transactions.
After post tendering, the display will show the remaining amount and the drawer will
open.
AMOUNT
EX )
CONV CASH/TENDSUBTLDEPT. or PLU
CASH/TENDSUBTL DEPT. or PLU
CASH/TEND
5 0 0 CASH/TENDSUBTL DEPT 3DEPT 1
CASH/TEND2 0 0 0
To Next Page
Loading...
