Sampo SR1046PRO User Manual

- 47 -
SR 1046PRO
instruction manual
H a r v e s t e r
2/2012
Parameters in the iqan control system
Below you can find a list with explanations of the data adjustable and observable on the
display.
INPUTS
Voltage Inputs:
VIN Tilt Sensor [°] The crane side tilt sensor (range -15°...+15°)
VIN Hand throttle Select the diesel engine revolution direction
VIN Fuel sensor Fuel level sensor
VIN Hydraulic oil temperature Hydraulic oil temperature sensor
VIN Alarm symbols An indicator for low hydraulic oil level, blocked diesel
engine intake air filter as well as for blocked vacuum,
pressure and return filter of the hydraulics
Digital Inputs:
DIN Ignition Ignition key information
SW Activation A door switch that stops the crane, frame steering
and rotator movements
DIN Joint angle Sensor that grounds the input when the frame
steering angle is wide
DIN Steering/rotator [%] Selects whether the right joystick controls the stee
ring of the frame or rotation of the head°
Mini/EME sidetilt right Side tilt switch data (mini/EME lever)
Mini/EME sidetilt left Side tilt switch data (mini/EME lever)
Banana sidetilt right Side tilt switch data (vertical grip)
Banana sidetilt left Side tilt switch data (vertical grip)
Harvester Head closed Head closed (vertical grip/EME lever)
Harvester Head open Head open (vertical grip/EME lever)
SW Steering angle End dampening sensor for articulated steering
DIN Side tilt automation on Selects whether the crane side tilt automation is on or off
DIN Side tilt automation reset After the start of the harvester or manual use of the
side tilt, the crane does not return to the center posi
tion automatically until the reset button is pressed.
DIN Side tilt automation reset
(vertical levers) After the start of the harvester or manual use of the
side tilt, the crane does not return to the center posi
tion automatically until the reset button is pressed on
the vertical levers.
SW Differential lock switch act. Differential lock switch information.
DIN Drive pump zero angle sensor Sensor that grounds the input when the drive pedals
NPN are in the center position
DIN Gear 1 engaged Sensor for gear 1
DIN Gear 2 engaged Sensor for gear 2
DIN Four wheel drive button Four wheel drive switch information
DIN Four wheel drive lock button Four wheel drive lock switch information

Sampo SR1046PRO Specifications

General

Brand	Sampo
Model	SR1046PRO
Category	Tractor
Language	English