The hydraulic oil does not need to be drained
when changing the filters. When changing the
suction filter in the traction hydraulics, you
need a pan to collect about 1.5 litres of oil
that is drained.
See further instructions in item SERVICE
MEASURES EVERY 1500 HOURS
6. Changing of gearbox oil
The oil is drained by unplugging oil drain A (fig.
43). New oil is poured into filler B. Gearbox
oil amount is ca.4 litres. The oil level shall be
between the bottom of the dipstick and the
mark on the dipstick with the dipstick screwed
on. Check and clean breather C on the cover.
Used oil is problem waste, which shall be
disposed of in an appropriate manner.
Use an oil type in accordance with the oil table
(see chapter
).
7. Checking condition of hydraulic hoses
Check The condition of hoses. Replace worn
out and leaking hoses to New. Replace all hoses
with new ones at least once in 15 years.
8. Checking air hoses of cooler and
engine
Check hoses visually. Replce with new if needed.
Engine’s cooling water hoses must be changed
at least every five year.
9. Adjust diesel engine valves
See instructions in the engine maual.
Service measures every 1 500 hours
1. All service measures to be performed daily, weekly, every 100 and 500 hours
The service to be performed every 1500 hours includes all the service measures listed under
service measures daily or every 8 hours, service measures weekly or every 50 hours , service
measures every 100 and service measures every 500 hours.
To Next Page
Loading...
General