Storage when not in use
In case of a longer storage, the pre-storage service is recommended . The pre-storage service
can be divided into three parts, in order of performance: cleaning, checking and protection.
Cleaning:
Dirt is efficiently removed from a dry harvester by compressed air. A high-pressure washer
may also be used with caution. To reduce drying time, use warm water. Do not direct water
jets at the bearings, as the packing does not hold against a strong spray of water. Apply suit-
able solvent on heavily greasy spots before washing. Start cleaning from the top. Clean the
radiator cells by blowing air from the direction of the wings.
Checking:
Take a pen and paper and write down all the shortcomings and required service measures in
the following order:
• Condition of the harvester head
• Bearing clearances and attachments
• Wear, corrosion and dents
It is important to have the recorded defects repaired before storage to ensure the efficient
functioning of the harvester in the future.
Protection:
Use engine oil or special protective oil in a sprayer.
Places to be protected:
• Scratched paintwork (paint)
• Electrical connections (special protective spray)
Cab ventilation:
Clean the filters. Clean the air channels and the fan unit with its cells. This may be done with
a vacuum cleaner.
Air Conditioning:
Clean the air conditioner condenser and vaporiser cells preferably with compressed air.
Engine:
Clean the engine externally.
Replace the fuel filter.
Change the engine oils.
Replace the engine oil filter.
Check the anti-freezing quality of the coolant.
Clean or replace the air filter.
Clean the cable lugs and apply grease to them.
Electrical instruments:
Clean the battery surfaces, check the fluid level and charge the battery full. Charge the battery
every three months.
To Next Page
Loading...
General