4. Checking of the condition of traction
transmission
Check the attachment of final drives, drive
shafts and gearbox. Ensure there are no cracks.
Check the attachment of the hydraulic pump
and motors in traction transmission. Check for
leaks in hose connections.
5. Cleaning of cab air filter
Remove the cab fresh air filter with its hous-
ing and clean it carefully with compressed air.
Replace a soiled or broken filter. The paper
filter shall be replaced at least once a year.
Check also the condition of the air intake
suction channel.
6. Checking of gearbox oil level
Clean the dipstick and breather area. The
oil level shall be between the bottom of the
dipstick and the mark on the dipstick with the
dipstick screwed on. Refill in compliance with
the oil table (fig. 33).
7. Checking of light operations
Make sure the headlights, working lights, turn-
ing signals and signal lights function prop-
erly. When replacing bulbs, comply with the
Manufacturer´s recommendations.
8. Draining of water out of water
separator
The fuel pre-filter with water separator is located
on the left side of the engine Drain any accu-
mulated water into a dish weekly. Replace the
filters in compliance with the service table or
more often if you suspect a clogged filter. Fault
code “Fuel pressure low” indicates a clogged
pre-filter or air leakage in the pipes. When
changing the filter, remember to take the metal
water separator plug from the old filter.
Used filters are problem waste that must be
dealt with accordingly. For further instructions,
refer to the engine manual.
9. Checking of oil level in final drives
Clean around the control opening and breather.
The oil level should come up to the control
opening. When necessary, refill oil through the
breather until oil runs out of the control open-
ing. Refit the breather and control plug and
wipe off excessive oil (fig. 34).
10. Checking of brake functions
The brakes shall be adjusted regularly due
to the wear of the brake bands. The free
travel of the brake pedal shall be 20-50 mm.
Make sure the harvester cannot move, start
A Control opening
B Breather
To Next Page
Loading...
General