OfficeServ 7400 INSTALLATION
TECHNICAL MANUAL PART 3 MAY 2010
3.57
SETTING UP THE SVMI-20E WITH THE OFFICESERV 7400 PHONE
SYSTEM
This section provides the additional steps required to set up the SVMi-20E card for operation
in the OfficeServ 7400 system. Included here is information regarding the software set up for
the phone system.
After inserting the SVMi-20E card and turning the power on there are some important system
options that should be set in order for the SVMi-20E to function correctly. These steps are
performed in the phone system program. It is necessary to perform these at this time so that
the SVMi-20E will initialize properly and synchronize its mailbox database with that of the key
system.
SYSTEM PROGRAMMING
Review and perform the following programming steps 1 through 7. It is necessary to perform
these at this time so that the SVMi-20E will read these MMCs and initialize accordingly.
NOTE: Before moving forward if you want to change any of the SVMi-20E default Extension
and Mailbox settings it is best to edit your Extension and Mailbox Templates now before
initializing the SVMi-20E.
1. MMC 601: All SVMi-20E ports installed must be assigned to the last station group (by
default the last group number is 5049). This should be identified as Bi-VMS group type by
OSM or Installation Tool.
2. MMC 601: Select either SEQUENTIAL or DISTRIBUTED ring mode (Sequential is
recommended).
3. MMC 207: Confirm that all SVMi-20E ports are set for VMAA use. This will be done
automatically. You are just confirming at this point.
4. MMC 406: If you are using the SVMi-20E for Auto Attendant use MMC 406 to set the
desired trunk(s) to ring station group 5049.
5. MMC 102: If you are using the SVMi-20E for Voice Mail make sure that all desired stations
are forwarded to station group 5049 for the appropriate call forward conditions: No-
Answer, Busy, and/or ALL.
6. MMC 740: Set “MBX Download” is to YES.
7. MMC 741: Select "NO" for each station that you DO NOT want to create a mailbox for.
To Next Page
Loading...
