- 5/65 -
Step 1
① Push the DISPENSER LEVER to check Auger
Motor rotating sound. Auger motor is in
the Ice Room.
- If No operation sound, go to Step 2
inspection
- If operation sound, go to Step 4
inspection
Step 2
① Check Auger Motor S/W that is on the top
of Left FF Section Door.
- Inspect S/W with F room door closed
② Using an Ohmmeter, check for“0Ω” with the
S/W plunger pushed in by hand.
※ If the door S/W has failed, the auger
motor cannot work.
Step 3
① Disassemble the Display and check the Micro
LED S/W, located at the back of the Lever.
※ (Check for broken or stuck switches)
When there is no problem found,
① Disassemble HINGE-UPP COVER, and check
the WIRE HARNESS connection
- Inspect CONNECTOR
No.7(BLU)+No.15(GRY)
② Inspect Main PBA Connector
- Inspect CN50 No.5(YEL) and No.7(BLU)
Wire
Check Point
Inspect the Dispenser Lever S/W operation.
Tip 1-2. Inspect Lever S/W & Auger Motor S/W operation
BLU
GRY
Next Page
To Next Page
Loading...
