Alignment & Adjustments
Service Manual
4-27
Samsung Electronics
Replace Drum
Retry Redial?
Scanner locked
Self Diagnostic LSU
Self Diagnostic
Temperature
Send Error (AUTH)
Send Error (DNS)
Send Error (POP3)
Send Error (SMTP)
Send Error
(Wrong Config)
[Stop Pressed]
Tray 1 Paper Empty
Tray 2 Paper Empty
The drum cartridge is at the end of its life.
The machine is waiting for a specified time
interval to redial a previously busy station.
The scanner module is locked
The LSU (Laser Scanning Unit) in your
printer is checking some problems detected.
The engine in your machine is checking
some problems detected.
There is a problem in SMTP authentication.
There is a problem in DNS.
There is a problem in POP3.
There is a problem in SMTP.
There is a problem on the network interface
card.
Stop/Clear has been pressed during a fax
transmission.
There is no paper in the tray 1.
There is no paper in the optional tray 2.
Replace the drum cartridge.
You can press OK to immediately redial, or
Stop/Clear to cancel the redial operation.
Unlock the scanner and press Stop/Clear.
Please wait a few minutes.
Please wait a few minutes.
Configure the authentication setting.
Configure the DNS setting.
Configure the POP3 setting.
Change to the available server.
Configure your network interface card
correctly.
Try again.
Load paper in the tray 1.
Load paper in the optional tray 2.
Message Meaning Suggested solutions
To Next Page
Loading...
Need help?
General
