6. Lift the Guide Duplex Ass’y at the front hinge. It may
be necessary to gently flex the plastic frame to
release the hinge. Take out the Guide Duplex Ass'y,
as shown below.
7. Remove the two screws securing the Support Pickup
Ass'y. Look under the edge of the Support Pickup
Ass’y and release the spring from the Pickup Ass’y.
Then remove the Support Pickup Ass’y, as shown
below.
8. Unplug the one connector and remove the circlip on
the end of the shaft. Remove the Clutch. Remove 2
further circlips and bushes then take out the Pickup
Ass'y, as shown below.
9. Unplug The Gate Sensor connector and remove one
screw securing the ground cable.
Samsung Electronics
Service Manual
5-8
To Next Page
Loading...
