Santerno DCREG4.150 - M024: Output Power; M025: Motor Torque; M026: Enp;Nr Frequency; M027: Drive Life

DCREG2 15P0059B3
DCREG4 USER MANUAL
129/200
7.1.25 M024: OUTPUT POWER
M024 OutputPower
P
M024 – POut
Pout **** kW
R
0 … 5250 kW
F
This parameter indicates, in kW, the power supplied to the load, as a division by
1000 of the output voltage product (par. M006) for the output current (par.
M004).
7.1.26 M025: MOTOR TORQUE
M025 MotorTorque
P
M025 – Torque
Torque **** %
R
-180. … 180. %
F
It displays, as a percentage of the motor nominal torque, the motor torque as a
product per cent of the armature current by the field current. 100% of this
parameter is obtained with the motor armature nominal current (set by par.
C000) and the motor field nominal current (set by par. C010).
7.1.27 M026: ENP/NR FREQUENCY
M026 EnP/NrFreq
P
M026 – EFreq
EFreq ****** k Hz
R
-102.4 … 102.4 k Hz
F
This parameter displays, in k Hz, the frequency of the enP/Nr used as a speed
feedback.
7.1.28 M027: DRIVE LIFE
M027 Drivelife
P
M027 – Drivelife
*****h **m
R
0 ... 235926000 s (approx. 7 years and a half), size ..h ..m
F
This parameter indicates the drive overall operation time starting from its first
power-on. This value is stored each time the power section is shut off.
7.1.29 M028: PHASESEQ
M028 PhaseSeq
P
M028 – PhaseSeq
* * *
R
RST … TSR
F
Indicates which is the phase sequence supplying the drive section power with
reference to bars L1-L2-L3 respectively.