SANY SY75 - Engine Coolant Level - Check

SY75C Excavator OMM Maintenance Procedures
SANY Operation and Maintenance Manual — 0220 5-35
TABLE OF
CONTENTS
INTRODUCTIONSAFETY
MACHINE
CONTROLS
MACHINE
OPERATION
MAINTENANCESPECIFICATIONS
OPTIONAL
EQUIPMENT
Engine Coolant Level - Check
1. Locate coolant recovery tank (a) behind the left rear door.
2. Verify that the coolant level is between the L and H marks on the coolant recovery tank.
3. Add coolant as necessary to a level between the L and H
marks on recovery tank (a).
4. Start the engine and run it at low idle speed (1,050 rpm)
for five minutes.
5. Shut down the engine.
6. Recheck the coolant level.
7. Add more coolant if necessary
DANGER!
Inhaling or ingesting coolant is toxic. If not avoided, this will result in death or injury8.
WARNING!
Do not remove the radiator cap while the engine is hot. Engine coolant is under pressure
when hot and will spray out. Always wait for the engine to cool before removing the radiator
cap. Failure to follow this warning could result in death or injury.
NOTICE!
Dispose of the coolant oil in accordance with local environmental regulations. Failure to do so
could result in damage to the environment.
Fig. 5-36
a