SANY SY75 - Work Equipment Operation

Control Work Equipment SY75C Excavator OMM
4-22 Operation and Maintenance Manual — 0220 SANY
CONTROL WORK EQUIPMENT
SAE Control Pattern
NOTE: “SAE Mode” on page 3-17.
Swing
Move the left joystick to the left to swing the work
equipment to the left. Move the left joystick to the right to
swing the work equipment to the right.
NOTE: The swing function is the same for SAE and
BHL.
Arm
Move the left joystick forward to extend the arm. Move the
left joystick rearward to retract the arm.
WARNING!
Never allow any personnel to be within 26 ft. (8 m) of the rear of the machine while it is
moving.
Be aware of all crush points on the machine and ensure that all personnel keep clear of these
areas.
Failure to observe and follow these warnings could result in death or injury.
Fig. 4-53
Fig. 4-54