Press and hold the MENU and a number
button (1–8) for more than five seconds to
switch among the codes.
Press and hold the MENU and a number
button (1-8) that corresponds to the
remote control code for more than five
seconds to switch among the codes.
Part Names and Functions
Remote Control Code
Adjustable Feet
1
2
To reset the remote control code, press and
hold the MENU and the number button 0 for
more than five seconds.
The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the
remote control codes prevents interference from other remote controls when several projectors or video
equipment next to each other are being operated at the same time. Change the remote control code for
the projector first before changing that for the remote control. See “Remote control” in the Setting Menu on
page 62.
MENU button
Number buttons
(1-8)
ON/OFF
Switch
Adjustable
Feet
Projection angle can be adjusted up to 6.5 degrees with
the adjustable feet.
Rotate the adjustable feet and tilt the projector to the
proper height; to raise the projector, rotate the both feet
clockwise.
To lower the projector or to retract the adjustable feet,
rotate the both feet counterclockwise.
To correct keystone distortion, press the KEYSTONE
button on the remote control or select Keystone from
the menu (see pages 14, 30, 45, 52).
To Next Page
Loading...
Need help?
General
