Computer Input
PC System Menu
PC System Menu
1
2
PC system can also be selected manually.
The PC System Menu
Selected system is
displayed.
Press the MENU button to display the On-Screen
Menu. Use the Point
▲▼
buttons to select Input
and then press the Point
►
or the SELECT button.
Use the Point
▲▼
buttons to select System and
then press the Point
►
or the SELECT button.
Use the Point
▲▼
buttons to select the desired
system and then press the SELECT button.
3
Systems in this dialog
box can be selected.
Customized Mode (1-10)
set in the PC adjust Menu
(pp.37-38).
This projector automatically tunes to various types of computers with its Multi-scan system and Auto PC
adjustment. If a computer is selected as a signal source, this projector automatically detects the signal
format and tunes to project a proper image without any additional settings. (Signal formats provided in this
projector are shown on pages 88-89)
One of the following messages may appear when:
There is no signal input from the computer.
Check the connection between your computer
and the projector. (See “Troubleshooting” on
pp. 78-80.)
Auto
-----
The preset system is manually adjusted in the
PC adjust Menu. The adjusted data can be
stored in Mode 1-10 (pp.37-38).
Mode 1
PC Systems provided in this projector is
chosen. The projector chooses a proper system
provided in the projector and displays it.
SVGA 1
*Mode 1 and SVGA 1 are examples.
Computer System Selection
Automatic Multi-Scan System
Selecting Computer System Manually
When the projector cannot recognize the
connected signal conforming to the provided
PC Systems, Auto is displayed on the System
Menu box and the Auto PC adjustment function
works to display proper images. If the image is
not projected properly, a manual adjustment is
required (pp. 37-38).
To Next Page
Loading...
Need help?
General
