EasyManuals Logo

Sanyo PLC-HP7000L User Manual

Sanyo PLC-HP7000L
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
The input source changes each time you press the INPUT button on the side control or the remote
control as follows:
Input 1→ Input 2→ Input 3 → ...
Before using the INPUT button on the side control or the remote control, you must select a correct
input source by On-Screen Menu and the latest input source will be displayed.
Input Selection
Press the INPUT 1, INPUT 2, or INPUT 3 button on the remote control. The input source appears on
the screen as you press each button. Select the connected input source.
INPUT 1 button
Input 1
RGB (PC analog)
RGB (Scart)
HDMI
INPUT 2 button
Input 2
Video
Y,Pb/Cb,Pr/Cr
RGB
INPUT 3 button
Input 3
Video
Y,Pb/Cb,Pr/Cr
S-video
Side Control
Remote Control
* Only the Input button function is set Mode 1 in the Setting menu, the INPUT button is used for
switching input source. (p.53)
INPUT button*
Direct Operation
Remote Control Operation
Side Control/Remote Control Operation
INPUT 1/2/3 buttons
Remote Control
INPUT button*
RGB (AV HDCP)
RGB (PC digital)
32

Table of Contents

Other manuals for Sanyo PLC-HP7000L

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-HP7000L and is the answer not in the manual?

Sanyo PLC-HP7000L Specifications

General IconGeneral
Brightness7000 ANSI Lumens
Contrast Ratio2000:1
Lamp Life2000 hours (Normal Mode), 3000 hours (Eco Mode)
Lamp TypeUHP
Projection Size30 - 300 inches
Resolution1024 x 768 (XGA)
Projection MethodFront, Rear, Ceiling
Input ConnectorsHDMI, VGA, Composite Video

Related product manuals