Basic Operation
For detailed functions of each menu, see “Menu Tree” on pages 81-83.
Image select
For computer source, used to select an image level among Dynamic, Standard, Real, and Image 1-10
(p.39).
For Video source, used to select an image level among Dynamic, Standard, Natural, Cinema, and
Image 1-10 (p.47).
PC adjust
Used to adjust the parameters to match with the input signal format (pp.36-38).
Screen
For computer source, used to adjust the size of the image. [Normal/Full/Wide(16:9)/Zoom/True/
Custom/Custom adj./Digital zoom +/-/Keystone/Ceiling/Rear/Screen aspect/Reset] (pp.43-45).
For video or HDMI source, used to adjust the size of the image. [Normal/Full/Wide(16:9)/Zoom/Natural
Wide/Custom/Custom adj./Keystone/Ceiling/Rear/Screen aspect/Reset] (pp. 51-52).
Input
Used to select an input source (Input 1, Input 2, Input 3 or Network) (p.32).
Note: Network willnotbedisplayedwhenoptionalPJ-NetOrganizerisnotattached.
Guide
The key operation is displayed.
Setting
Used to set the projector’s operating configurations (pp.53-71).
Network
See the owner’s manual of “Network Set-up and Operation”.
Main Menu
Main Menu
Sub-Menu
Information
Display the input source information: Input, System, H-sync freq., V-sync freq., Screen, Language,
Lamp status, Lamp counter, Filter counter, Power management, Key lock, PIN code lock, Shutter
management, Simple mode, Remote control, and SERIAL NO. (p.28).
Image adjust
For computer source, used to adjust the computer image. [Contrast/Brightness/Color management/
Color temp./White balance (Red/Green/Blue)/Offset(Red/Green/Blue)/Auto picture control/
Advanced color/Sharpness/Gamma/Reset/Store] (pp.40-42).
For video or HDMI source, used to adjust the video image. [Contrast/Brightness/Color/Tint/Color
management/Color temp./White balance (Red/Green/Blue)/Offset (Red/Green/Blue)/Auto picture
control/Advanced color/Sharpness/Gamma/Noise Reduction/Progressive/Reset/Store] (pp.48-50).
To Next Page
Loading...
Need help?
General
