Sanyo PLC-XE32

-35-
Electrical Adjustments
Group/
Item
Item Name Function Initial Range Note
3
4 Sub Image Enable 1 0 - 1
0:Disable (Service Adjustment Dsiable,
Used all the Center Values
1:Enable (Service Adjustment Enable)
6 Zoom Accelerator Enable 0 0 - 1
0:Zoom Accelerator OFF,
1:Zoom Accelerator ON
No last memory
7 DZoom Reset by Keystone 0 0 - 1
0:Enable (Normal), 1:Disable (Dzoo
is not cancelled even if Keystone is
cancelled)
No last memory
8 Stability Count Count Value of V-missing 5 0 - 255
9
Sensivity for Signal Lost
(HSYNC)
Only used this value for No Signal
Judgement(Hz)
350 0 - 65535
10
Sensivity for Signal Lost
(VSYNC)
Only used this value for No Signal
Judgement(Line)
3 0 - 255
11 Keystone Filter Center Value 16 0 - 30
Group
210
LampContorl
0 DIMMER_CTRL_LEVEL1
Luminance Level 1 Data for Dimmer:
Dim Level 1 at the less than the Value
9 0 - 255 Philips 200W
1 DIMMER_CTRL_LEVEL2
Luminance Level 2 Data for Dimmer:
Dim Level 2 at the less than the Value
18 0 - 255
2 DIMMER_CTRL_LEVEL3
Luminance Level 3 Data for Dimmer:
Dim Level 3 at the less than the Value
26 0 - 255
3 DIMMER_CTRL_LEVEL4
Luminance Level 4 Data for Dimmer:
Dim Level 4 at the less than the Value
35 0 - 255
4 DIMMER_CTRL_LEVEL5
Luminance Level 5 Data for Dimmer:
Dim Level 5 at the less than the Value
44 0 - 255
5 DIMMER_CTRL_LEVEL6
Luminance Level 6 Data for Dimmer:
Dim Level 6 at the less than the Value
53 0 - 255
6 DIMMER_CTRL_LEVEL7
Luminance Level 7 Data for Dimmer:
Dim Level 7 at the less than the Value
61 0 - 255
7 DIMMER_CTRL_LEVEL8
Luminance Level 8 Data for Dimmer:
Dim Level 8 at the less than the Value
70 0 - 255
8 DIMMER_CTRL_LEVEL9
Luminance Level 9 Data for Dimmer:
Dim Level 9 at the less than the Value
79 0 - 255
9 DIMMER_CTRL_LEVEL10
Luminance Level 10 Data for Dimmer:
Dim Level 10 at the less than the Value
88 0 - 255
10 DIMMER_CTRL_LEVEL11
Luminance Level 11 Data for Dimmer:
Dim Level 11 at the less than the Value
96 0 - 255
11 DIMMER_CTRL_LEVEL12
Luminance Level 12 Data for Dimmer:
Dim Level 12 at the less than the Value
105 0 - 255
12
DIMMER_CTRL_LEVEL13
Luminance Level 13 Data for Dimmer:
Dim Level 13 at the less than the Value
255 0 - 255
13 DIMMER_CTRL_LEVEL14
Luminance Level 14 Data for Dimmer:
Dim Level 14 at the less than the Value
255 0 - 255
14 DIMMER_CTRL_LEVEL15
Luminance Level 15 Data for Dimmer:
Dim Level 15 at the less than the Value
255 0 - 255
15 DIMMER_AVERAGE_POINT
Luminance Data Avarage Point for
Mimmer
4 0 - 16
16 DIMMER_AVERAGE_DATA
Luminance Data Avarage Value for
Dimmer
- - * Read only
17 DIMMER_LEVEL_AUTO Current Dimmer Leverl - - * Read only
18 DIMMER_LEVEL_NORMAL Normal Dimmer Level 12 0 - 15
19 DIMMER_LEVEL_ECO Eco Dimmer Level 0 0 - 15
20
Lamp check enable 1
0: Lamp Failure Detection OFF (White
50% Back), 1 : ON (Blue 100% Back)
21
VOLTAGE_LEVEL Lamp Voltage Unit: 8bit(Raw Data) * Read only
Group
250
FAN Cntorol
Nor-
mal
Ceiling
Nor-
mal-
HiLand
Ceiling-
HiLand
0 FAN_TEMP_A_WARNING
Temperature A to judge the Temp.
Failure
Outside
43 43 37 37 30-100 (Memorized)
1 FAN_TEMP_B_WARNING
Temperature B to judge the Temp.
Failure Panel
66 64 55 56 30-100 (Memorized)
2 FAN_TEMP_C_WARNING
Temperature C to judge the Temp.
Failure Lamp
73 73 64 67 30-100 (Memorized)
3 FAN_TEMP_B A_WARNING
Temperature B-A to judge the Temp.
Failure Filter Cloggled
100 100 100 100 0-100
(Memorized)
4 FAN_TEMP_C A_WARNING
Temperature C-A to judge the Temp.
Failure Filter Cloggled
100 100 100 100 0-100
(Memorized)
5 FAN__SPEED_MONI Fan Speed Monitor - - - - - * Read only
6 FAN__SPEED_MONI Fan Speed Monitor - - - - * Read only
7 FAN_TEMP_A_MONI Temp. Sensor Monitor - - - - * Read only
8 FAN_TEMP_B_MONI Temp. Sensor Monitor - - - - * Read only
9 FAN_TEMP_C_MONI Temp. Sensor Monitor - - - - * Read only
10 Lamp Mode High/Auto/Normal 1 0-2 0: High, 1: Auto, 2: Normal
11 Fan Ctrl Mode Normal/Ceiling Switch 0 0-1 0: Normal, 1: Ceiling