Sanyo PLC-XM150L User Manual

-14-
Maintenance
When replacing the lens or using an optional lens, install the lens by following the instructions below.
Remove the lens mount cover.
Fit the lens to the projector by aligning the red dot
on the lens with the red dot of the projector.
Slowly turn the lens clockwise until it clicks. Make
sure that the lens is fully inserted to the projector.
1
2
Attaching the lens to the projector
3
Red dots
CAUTION
Do not press the lens release button when at-
taching the lens.
Lens Installation
Shift the lens to the center position by using the
Lens shift function.
Turn off the projector and unplug the AC power
cord.
While pressing the Lens release button on the top
of the cabinet, turn the lens counterclockwise until
it stops and pull it out slowly from the projector.
1
2
Removing the lens
Lens Release button
CAUTION
Be careful when handling the lens. Do not
drop.
3

Sanyo PLC-XM150L Specifications

General

Vertical scan range	48 - 100 Hz
Horizontal scan range	15 - 100 kHz
Projection technology	LCD
Contrast ratio (typical)	1000:1
Projector native resolution	XGA (1024x768)
Lamp type	NSH
Lamp power	330 W
Light source type	Lamp
Service life of light source	2000 h
Service life of light source (economic mode)	3000 h
Analog signal format system	NTSC, PAL, SECAM
S-Video inputs quantity	1
Dimensions (WxDxH)	489.5 x 371.1 x 164 mm
Noise level	38 dB
Power consumption (standby)	0.6 W
Power consumption (typical)	400 W
Power consumption (economy mode)	338 W

Weight and Dimensions

Weight	8900 g